Mophie juice pack PRO Manuel d'utilisateur télécharger pdf (Page 2)

➊ Attach your phone to the battery

and bottom/connector piece.

The rst thing you need to do is separate the rubber boot from the case. The boot covers a plastic exoskeleton

that the phone ts in. The rubber boot is a tight t to ensure complete protection against dirt, sand, and

splashes. The best way to open the case is to start at the bottom, between the LED status indicator and the

mophie logo on the front, by lifting the small tab to begin to separate the rubber boot from the plastic.

After you remove the rubber portion of the case, you will be left with the plastic case. That separates into two

pieces. The rst is the screen protector and sides. The second is the battery and bottom/connector piece.

The front (screen) piece clips onto the back (battery) portion. There are four attachment points, two on either

side. Once you release one or more of the points, the two pieces should separate rather easily.

After the case is disassembled, the phone ts onto the 30 pin connector and rests in the case. Reattach the

screen protector and the phone will be enclosed in the case. The last part is stretching the rubber boot

back over the case. This might seem awkward and it will take a little getting used to. Make sure you have the

rubber portion tucked in around all the bumps to ensure proper protection. Once again, this might take a

little time and getting used to, to get it just right.

➋ Connect the screen protector

over front.

➌ Strecth the rubber boot over

the entire case.

Assembly instructions for the mophie juice pack PRO

Dissemble and assemble

1 2 3 4

Pas de commentaire

Mophie juice pack PRO Manuel d'utilisateur Page 2